Pressed Flower Resin Coasters

Instructions

1. Gather 12 dried flowers of your choice, ensuring they are flat and free of moisture.

2. Measure 12 oz of epoxy resin and 12 oz of hardener using a measuring cup.

3. Mix the resin and hardener in a mixing container for 3 minutes with a stir stick until fully combined and clear.

4. Pour a thin layer (about 1/4 inch) of the mixed resin into each of the six coaster molds.

5. Carefully place two to three dried flowers in each mold, ensuring they are submerged in the resin.

6. Use a heat gun or torch to remove any bubbles that rise to the surface after pouring.

7. Allow the resin to cure for 24 hours at room temperature.

8. After 24 hours, carefully demold the coasters from the silicone molds.